- 100% weatherproof
- Maintenance free
- Speeds on-site installation
- Ultimate protection
Full installation details are available on request from the Technical Department.
- Apply starting piece and slide the Dry Verge Unit (pointing towards the apex) until the Verge Unit butts against the end of the first tile. Screw the Verge Unit through the top and bottom holes, so that the screw penetrates the barge board or brick and firmly holds the Dry Verge in place.
- Clip together a second Dry Verge Unit and push it onto the tail of the first, until both sides of the clip engage with the tail fins of the first. Once again ensure the Verge Unit butts against the end of the tile. Then screw the tail end of the Verge Unit through the rear hole so it attaches to the barge board.
- Repeat instruction 2 until all tiles have been covered. Once the Left Hand Verge is completed, repeat on the opposite Verge using the Right Hand Verge Units. The Ridge Cap is then securely screwed into the dry verge.
Dry Verge Left Hand
Left hand piece of Corovent DVS Dry Verge System
Dry Verge Right Hand
Right hand piece of Corovent DVS Dry Verge System
Ridge Cap Angled
End cap for use with Corovent DHS Dry Hip System
Starter Piece for use with Corovent DHS Dry Hip System